Insulation Contractor in Anthony, NM - Attics Sealed Before They're Filled
Wraptight El Paso Insulation Company is an insulation contractor based in El Paso that insulates and air seals attics, walls and crawl spaces for houses and small commercial buildings in Anthony, NM, across the state line.
- Licensed and insured.
- Free in-person estimates.
- We reply within 1 business day.
Insulation work in Anthony, New Mexico
Anthony sits on the New Mexico side of the state line, a short drive up from El Paso, and we work here the same way we do in Canutillo just down the road or San Elizario on the far side of the city. Most of our calls here are single-family houses, a good share of them older, plus newer homes toward the edges of the city and the odd small shop or office. The attic we find most often had insulation added once, years ago, and hasn't been touched since.
The price here moves with the size of the attic or walls, how many inches are already up there and whether old material has to come out first, and the schedule turns mostly on that removal and on any repair that has to happen before us. I put your own figure on the estimate after I've been up there. Older houses usually need more sealing before any new insulation goes down, because the gaps around the hatch, pipes and light fixtures have had years to open up.
What we do on Anthony houses
Attic insulation
A lot of the attics we open here still have the one layer someone put down years ago, now settled and pushed around by later repairs. We measure what's left, fix what's underneath, and bring the whole attic up to an even depth.
Attic air sealing
On older houses the gaps around the hatch, can lights, pipes and wall tops let attic air straight into the rooms, which is a big part of why the place feels drafty. We close those gaps first, because insulation laid over an open gap just has a draft running through it.
Insulation removal
When the old material is soaked from a past roof leak or full of droppings, topping it up only buries the problem. We bag it out, clean the attic floor and look for the cause before anything new goes in.
Retrofit insulation
Plenty of older houses here have little or nothing in the outside walls, so a room can feel cold along that wall even with a full attic overhead. We fill the finished walls through small openings and patch them, so you keep your walls.
Spray foam insulation
The room over the garage often runs hot in one season and has cold floors in the other, because its floor and sloped ceiling are hard to fill with loose material. We use spray foam there when it fits, since it seals the air gaps while it insulates.
Basement insulation
Not many houses in Anthony have a basement, but where there's one or a below-grade room, bare walls are usually why it stays damp and chilly. Our basement insulation work starts with finding where moisture gets in, then we insulate the walls so it doesn't get trapped behind them.
What Anthony houses usually need first
The weak spot in most Anthony attics is the edges, where the roof comes down low and the insulation runs thin or gets packed into the eave vents. Buried vents stop the attic from breathing, so moisture can start showing in the framing, and thin edges are why the rooms along the outside walls run hot and the power bill climbs. We clear the vents first, seal the gaps, and build the edges up to match the middle, because that's where the old job usually came up short.
A lot of houses here have been added onto over the years, a converted garage or a room on the back, and the spot where the addition meets the old roofline usually has a gap nobody sealed. I look at those joints on every estimate, because that's where we most often find the draft.
Get a free on-site insulation estimate in Anthony
Send the form or call (915) 265-1142, and we'll reply within one business day to set a time. I come out to your Anthony house myself, look at the attic and anything else you're worried about, and write the estimate with each step listed. It's free, and there's no obligation.
Insulation questions from Anthony homeowners
These are the questions we hear most from Anthony homeowners. If yours isn't here, call or send the form and describe the job, and I'll answer it when I come out.
Do I need a permit to insulate my attic in Anthony, NM?
You may, so I check your address with the city before we plan the job. The City of Anthony requires building permits for all construction within the city, reviewed by its Building Inspections Department, and the state requires a permit before a building is altered or repaired unless a rule says otherwise. When a permit applies, we take care of the application and the inspections.
How do I check that an insulation contractor is licensed in New Mexico?
Ask for the company's New Mexico license and what classification it covers, because the state Construction Industries Division licenses the business, and a license covers only the work in its classification. The state also requires licensed companies to carry a license bond and workers' compensation, and the city has businesses register with it each calendar year before doing business there. We're licensed and insured, and you can ask me about any of it at the estimate.
If you find bad wiring in my attic, can I fix it myself in New Mexico?
Only after you've passed the required state exam for that work, because the division's residential permit guide says a homeowner does electrical work only after passing it. Otherwise it's a job for a licensed electrician. I'll tell you plainly when the insulation has to wait for that repair, since covering bad wiring just hides it.
How much does attic insulation cost in Anthony, NM?
The cost comes down to the size of the attic and how much work has to happen before new insulation goes in. Removing soaked or dirty material and sealing gaps add to the job, and spray foam costs more than blown-in, which is loose fill blown through a hose. I price each of those parts so you can see which ones your house actually needs.
How long does attic insulation take, and when can we go back inside?
With blown-in work you can usually stay home, but with spray foam you, the kids and the pets stay out until the re-entry time, which is the wait the foam maker sets before people come back in. How long the crew is in your attic turns mostly on the prep, since removing old material and sealing gaps take longer than laying the new insulation. Ask me when I come out, and I'll go over the timing for your house.
What is the best way to insulate an attic in Anthony, foam or blown-in?
For most Anthony attics, sealing the gaps and topping up with blown-in does the job for less. Foam costs more because it seals the air and insulates in the same pass, so I recommend it mainly when the ductwork runs through the attic and you want that space sealed in with the house.
Insulation work, up close
Other cities we work in
Check the list for other cities with their own page, or call or send the form to ask about your address.