Insulation Contractor in Horizon City, TX - Attics Sealed Before They're Filled
Wraptight El Paso Insulation Company is an insulation contractor working in Horizon City, TX. We seal attic gaps, top up thin insulation, pull out old or damaged material and insulate walls in the order your house needs.
- Licensed and insured.
- Free in-person estimates.
- We reply within 1 business day.
Insulation work in Horizon City homes
Horizon City is a short drive from where we're based in El Paso, and we work here the same way we do in Socorro and across the state line in Chaparral, NM. I come out to every house myself, go up into the attic and write the estimate, because what's already up there and what has to happen before new insulation goes in set both the price and the schedule. You get the estimate in writing, with each step listed, so you can see what your number covers.
Most calls here come from subdivision houses, one and two stories, with a vented attic and often a room over the garage that runs hotter than the rest of the house. Those attics usually still hold the blown-in insulation, loose fill blown through a hose, that went in when the house was built, so the job is less about starting over and more about fixing what's thin, buried or never sealed.
What we do on Horizon City houses
Attic air sealing
A lot of Horizon City attics have open gaps around can lights, pipes, wire holes and the hatch, so air from the rooms below leaks straight up. Air sealing, closing those gaps before any insulation goes in, comes first on almost every attic we do, because insulation laid over a draft can't do its job.
Blown-in insulation
When the original fill in your attic is clean and dry but thin, topping it up with blown-in is usually the better spend than tearing it out. We seal first, then blow new fill to an even depth across the whole attic.
Insulation removal
If the old fill is soaked from a roof leak or full of droppings, new material on top just keeps the problem in your house. We handle insulation removal by vacuuming it out, I check the roof boards and wiring once it's clear, and only then do we seal and insulate.
Wall insulation
The room over the garage is the one people here call about most, because its floor and short side walls usually got less insulation than the rest of the house. We fill those walls and the floor over the garage, and seal where the room meets the attic so the air stays put.
Spray foam insulation
Some houses here run their ductwork through the attic, and that's where foam earns its higher cost, because it seals air and insulates in one pass. If your ducts aren't up there, I'll usually tell you sealing and loose fill is the better use of your money.
Commercial insulation
Property managers and owners of small offices and shops in Horizon City call us when a building needs to be checked and brought up to standard. We write up what we find, fix it in order and I check the work before we leave, so you have a clear record of what was done.
What Horizon City attics usually need
When I climb into an attic here, the first thing I measure is how many inches are already down, and the usual find is fill that's deep in the middle and thin over the outside walls, which is backward. I also look for eave vents buried under loose fill, because an attic that can't breathe holds moisture, and that shows up later in the framing. We clear the vents and keep them open before any new material goes in, so the fix doesn't create a new problem.
Order matters more than material. If I find a roof leak, a wiring problem or a duct that's come apart, the right trade fixes it before we insulate, because insulation over a leak or bad wiring just hides it, and I'd rather tell you the job has to wait. We're licensed and insured, and if you want a straight look at your attic, call (915) 265-1142 or use the form below.
Get a written insulation estimate for your Horizon City house
We reply within one business day. I come out to your Horizon City house myself, look at the attic and write a free estimate with each step listed, and there's no obligation to book. If you go ahead, our installers do the work and I check it before we leave.
Horizon City insulation questions
These are the questions Horizon City homeowners ask us most about permits, cost and timing. If your job isn't covered here, call or send the form and ask about your own house.
Do I need a permit to insulate my attic in Horizon City, TX?
The city's published permit list doesn't settle that for insulation, so I check your address with the Town of Horizon City's Building Services Department before we start. Building Services issues residential construction permits, and its list names re-roofs, fences, driveways, siding and sheds but not insulation, while saying the work it covers isn't limited to those items. When a permit applies, we take care of the application and the inspections.
Does my electrician need to register with the Town of Horizon City?
Yes, electrical, plumbing and mechanical contractors all have to register with the city, which keeps a copy of each one's master's license on file. A contractor who isn't registered gets denied permits or inspections, so ask yours to confirm it before they start. This comes up on insulation jobs when wiring, a bath fan or ductwork has to be fixed first, and each of those systems needs its own permit.
How do I schedule an inspection in Horizon City?
Call Building Services at 915-852-1875 by 4:00 PM the day before you want the inspection, and cancellations go by the same deadline. On jobs where we hold the permit, we call the inspections in ourselves. Keep in mind a permit expires 12 months after it's issued, and it goes invalid if work doesn't start within 180 days or stops for 180 days.
Can I apply for a building permit online in Horizon City?
Yes, the city's Online Permit Center lets you apply for permits and licenses, check where an application stands, pay fees and upload documents. Permit fees start at $70 for work that needs one inspection and run $140 and up for work that needs two. Starting regulated building, electrical, gas, mechanical or plumbing work before the permit is issued means paying the regular fee plus an equal amount, so it pays to wait.
How much does attic insulation cost in Horizon City?
Your price depends on what's already in your attic, and I give it to you in writing, with each step listed, after I've been up there. The biggest swings come from old fill that has to come out first, how many gaps need sealing, and whether ductwork in the attic makes foam worth its higher cost over loose fill. A tight attic with a low roof adds time, while a clean attic that only needs sealing and a top-up is usually the smaller job.
How long does attic insulation take, and when can we go back inside?
With blown-in fill you usually don't need to leave at all, and how long our crew is up there comes down to how much has to come out and how much sealing there is. Spray foam is different, because the foam maker sets a re-entry time, the wait before you, the kids and pets come back in, and we go by it. I go over both with you at the estimate so you can plan around the work.
Insulation work up close
Other cities we work in
Pick your city from the list to see how we work there, or call us if you don't see yours. We work in plenty of places beyond these pages.